The reason for the uneven length of the material discharged by the chip cutting machine

During normal use, the chip cutting machine may experience varying lengths of discharge. To avoid this situation, we need to identify the specific cause. Let's take a look together:
1. The straightening wheel of the chip cutting machine is loose, some wheels do not rotate, and the entry into the wood is not smooth, resulting in uneven and uneven wood output speed. At this point, we need to tighten the calibration wheel.

2. If the speed measuring wheel is rusted and worn, it can be lubricated or the bearing can be replaced. Alternatively, you can consider replacing the speed measuring wheel.

3. The encoder and connecting hose are loose. At this point, reinstall, tighten, or replace.
4. The spring on the chip cutting machine is loose. Replace the spring with a new one and check to release it at any time.
5. The speed measuring wheel may have broken teeth. If the broken tooth is not severe, you can simply repair it, but if it is severe, you can only replace the speed wheel.
Chipping machines are used for processing materials such as pine, miscellaneous wood, poplar, cedar, bamboo, etc., mainly in the density board industry. At the same time, the device can also be used for cutting fiber like straw materials such as bamboo, thatch, corn stover, sorghum stover, etc. Sawdust crusher can also be used as a raw material for particleboard and high-density sawdust board. This series of equipment is suitable for mobile operations, widely used in the material preparation section of small and medium-sized particle board and fiberboard enterprises, and can also be used for commercial wood chips for individual businesses.
When the chip cutting machine is working, the material can be finely crushed in the crushing chamber, with high output, low energy consumption, high efficiency, and uniform discharge. Low noise, minimal pollution, simple operation, and easy maintenance during use.