The material has a certain impact on the efficiency of the chip cutting machine

Many times,when a chip cutting machine malfunctions,it is not due to improper operation,but rather a failure to consider the factors of raw materials.The diversity of raw materials,hardness,dryness and wetness,and other factors also have a certain impact on the chip cutting machine in use.Generally speaking,wood is the main material,but its efficiency may also be affected under different conditions.What is the impact of materials on the efficiency of the chip cutting machine?Let's take a look together.

1.The harder the material,the more difficult it is to damage and wear out the equipment.The crushing speed is slow,the crushing capacity is small,and the efficiency will correspondingly decrease.

2.The better the wear resistance of the slicer,the greater its crushing ability.The fineness requirement for crushed materials is higher,that is,the finer the crushed material,the smaller the crushing ability.
3.The higher the viscosity of the material,the easier it is to adhere,and the adhesion of the material to the cutting machine will affect the progress of the equipment.
4.The more fine powder the material contains before crushing,the greater the impact force during crushing,as these fine powders tend to stick together and affect transportation.Materials with high content of fine powder should be screened in advance.
5.When the humidity of the material,that is,the moisture content of the material,is high,the material is prone to stick to the sawdust machine of the slicer,and it is easy to block during the transportation of the material,resulting in a decrease in crushing capacity,while the impact of dry material is relatively small.
The material has an impact on the efficiency of the chip cutting machine,and we can adjust the material according to the above introduction.Various factors such as hardness,composition,and viscosity of materials can affect the efficiency of the wood chip machine,but we cannot change these characteristics of raw materials.In order to ensure the normal operation of the equipment,we should do a good job in pre-treatment.