The dispersing effect of the wood chip machine

The wood chip machine is suitable for industries such as particleboard, medium density board, wood fiberboard, and papermaking, cutting small diameter logs as raw materials. After cutting, the raw materials become small wooden pieces, which can be used as raw materials for particleboard, medium density board, and fiberboard, as well as fuel. This wood chip machine has a wide range of applications, diverse raw materials, good and reliable cutting quality of wood chips, easy operation, and high production efficiency. Chipping machine is a specialized conveyor used in the mechanical feeding and conveying system for the preparation and cutting of artificial boards.

The wood chip machine has a function to disperse piles of logs, allowing them to enter smoothly and evenly. It can solve problems such as bridging and blockage in log feeding, uneven feeding and transportation of the wood chip machine. The vibrating conveyor utilizes the principle of spring vibration conveying, drives a special eccentric shaft as a power source through a motor, and generates two excitation force components during movement. One component causes the equipment to vibrate vertically, throwing materials up and loosening them; Another component causes the equipment to vibrate horizontally, promoting forward movement of materials and stabilizing direction.
The wood chip machine has a compact and reasonable structure, easy operation, high production performance, reliability, and convenient maintenance. The wood chip machine uses diesel or gasoline engines as power, but the production cost is higher than electric drive. Chipper can cut small diameter wood, veneer, Flat noodles, etc. Cut wood chips below 120mm can be used as materials for fiberboard and pulp; The disc wood chip machine can adjust the length of wood chips according to the different requirements of fiberboard and particleboard. The output value of the wood chip machine is greater than that of the drum wood chip machine because its structure is simpler and the processing flow is simpler.
The feeding groove of the wood chip machine is nearly square in shape, with a height and width that are basically equal, suitable for valuable logs, thinning wood, and tying tree branches. And it can achieve higher productivity. If used for processing small cross-section raw materials such as veneers and edge strips, it is difficult to fill the chute during feeding, and the production capacity of the equipment cannot be fully utilized; The feeding groove of the wood chip machine is mostly rectangular, with a small height and large width of the inclined groove, which has good adaptability to various shapes of raw materials. However, the wood chip machine is not suitable for cutting large-diameter logs because the flying blade of the wood chip machine moves in a circular motion, and the direction of the cutting force changes with the position of the flying blade.